Recommended Oils - K&S BASIC KSB 22i S Owner's Manual

Inverter generator in soundproof housing

Owner's manual (14 pages)

Owner's manual (71 pages)

Table of Contents

- If the generator often operates at high temperature or high load, the oil should be replaced every 25 operating hours.

- If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours.

- If you missed the maintenance time, perform it as soon as possible to save the generator engine.

IMPORTANT!

Use oils designed for four-stroke cycle vehicle engines

SAE10W-30, SAE10W-40. Motor oils with other viscosity levels,

may be used only if the average air temperature in your region

does not exceed the limits of the temperature range, specified

in the table.

Upon oil level decrease it is necessary to add the required quantity in order to provide the correct generator operation.

It is necessary to check the oil levels according to technical maintanance schedule. Further details can be found in the

full version of the manual on our website.

Air filter cleaning is to be performed each 50 hours of the generator operation (every 10 hours in unusually dusty

conditions).

CLEANING THE FILTER:

1. Open the clips on the upper cap of the air filter.

2. Remove the sponge filtering element.

3. Remove all dirt deposits inside the hollow case of the air filter.

4. Thoroughly wash the filtering element in warmsoapy water.

5. Dry the sponge filter.

6. Dry filtering element is to be moistened by motor oil and excess oil is to be squeezed out.

Spark plug has to be intact, without soot deposits and to have a correct gap.

SPARK PLUG VERIFICATION:

1. Remove the cap from the spark plug.

2. Remove the spark plug by means of a corresponding spanner.

3. Examine the spark plug. If is is shattered – it is necessary to replace it.

Recommended replacement spark plugs – F7TC.

4. Measure the gap. It has to be within range 0.7-0.8 mm.

5. In case of repeated use, the spark plug has to be cleaned by means of a metal brush.

After that – set the correct gap.

The engine and damper will get very hot after the generator has been started. Do not touch the engine or damper with

any part of your body or clothing during inspection or repair until they have cooled down.

Remove the screws and then pull the protective cover towards you. Loosen the bolts and remove the cover, screen and

flame arrester of the damper. Descale the screen and flame arrester of the damper with a wire brush.Inspect the screen

and flame arrester of the damper. Replace them if they are damaged. Replace the flame arrester. Replace the screen

and cover of the damper. Replace the cover and tighten the screws.

The manufacturer shall not be liable for any damage caused by

failure to perform maintenance work.

AIR FILTER TECHNICAL MAINTENANCE

SPARK PLUGS TECHNICAL MAINTENANCE

DAMPER AND FLAME ARRESTER MAINTENANCE