Installing The Battery; Connecting Lead Wires; Preparing For Session - TensCare sports TENS 2 Instructions For Use Manual

become hot, explode or ignite and cause injury
and /or damage:
Do NOT pierce, open, disassemble,
or use in a humid and/or corrosive
environment.
Do NOT expose to temperatures over
60°C(140F).
Do NOT
leave near sources of heat, in direct
strong sunlight, in a high temperature
location, in a pressurized container or in a
microwave oven.
Do NOT immerse in water or sea
water, or get wet.
Do NOT short-circuit.
Do NOT MIX 5V and 4.2V Power
Supplies and Cradles. This could
result in failure to charge or damage
to the battery.
If necessary, it is recommended to obtain a
replacement battery from your local distributor.
If battery leakage occurs and comes in contact
with the skin or eyes, wash thoroughly with lots
of water.
Keep batteries out of the reach of small
children.
Disposal: Always
responsibly according to local government
guidelines. Do not throw batteries onto a fire.
Risk of explosion.

15.2. INSTALLING THE BATTERY

1) Remove the battery cover by pressing
down the centre of the battery cover and
slide downwards.
put, store
dispose of batteries
2) Insert the battery into the unit. Line up the 3
connectors on the battery with the contact
in the unit. Slide in and press down.
3) Replace the battery cover.

15.3. CONNECTING LEAD WIRES

Insert the lead wire plug into the base of the
or
unit.
Rotate the body of the plug 90⁰ to lock the lead
wire in place.
Attaching the electrode pads to the lead
wire.
Push the pin ends firmly into the pigtail ends of
the electrode pads.
The lead wires may be damaged by rough
handling, and should be treated with care. To
avoid damage, remember to rotate the plug to
unlock it before removing the lead wire.
Lead wire colour coding.
The ends of the lead wires are coloured red or
black. When using the EMS and Massage
programmes, one of the electrode pads should
be positioned over the motor point (see sections
12.2. and 12.3.).

15.4. PREPARING FOR SESSION

1) Before use make sure your skin is clean
and dry.
2) Place the electrode pads on the skin, see
section 12.
3) If you are using your Sports TENS 2 while
moving, you can attach the unit to your belt
33