6
|
Unit installation
6.2.6 To open the service cover
6.3 Installing the indoor unit
6.3.1 Precautions when installing the indoor unit
6.3.2 To install the mounting plate
Installer reference guide
28
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
a Service cover screw
b Service cover
INFORMATION
Also read the precautions and requirements in the following chapters:
▪
General safety precautions
▪
Preparation
1 Install the mounting plate temporarily.
2 Level the mounting plate.
3 Mark the centres of the drilling points on the wall using a tape measure.
Position the end of tape measure at symbol " ".
4 Finish the installation by securing the mounting plate on the wall using
M4×25L screws (field supply).
INFORMATION
The removed pipe port cover can be kept in the mounting plate pocket.
A
a
1 17
d
a
e
48
170
A Mounting plate for class 20~35
a Recommended mounting plate fixing spots
b Pocket for the pipe port cover
c Tabs for placing a spirit level
d Through-the-wall hole Ø65 mm
e Drain hose position
f Position for the tape measure at symbol " "
g Gas pipe end
a
b
b
c
a
c
a
213
237
f
A
A
h g
a
a
a
170
50
337
337
770
116.5
d
e
48
(mm)
FTXP20~35N5V1B + ATXP20~35N5V1B
Split system air conditioners
4P519439-20U – 2022.09