To Open The Service Cover; To Remove The Front Grille - Daikin CTXM15A2V1B Installer's Reference Manual

6 | Unit installation

6.2.2 To open the service cover

6.2.3 To remove the front grille

Installer reference guide
24
2 Push the left panel shaft outward and up to disconnect the front panel from
the unit. (Remove the right side front panel shaft in the same manner.)
a
a Front panel shaft
3 After removing both front panel shaft, pull the front panel toward yourself
and remove it.
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
a
b
a Service cover
b Service cover screw
NOTICE
When closing the service cover, make sure that the tightening torque does NOT
exceed 1.4 (±0.2) N•m.
CAUTION
Wear adequate personal protective equipment (protective gloves, safety glasses,...)
when installing, maintaining or servicing the system.
1 Remove the front panel, see
remove the air filter.
2 Remove the service cover, see
3 Remove the lower flap by pushing it to the left side and towards you.
4 If installed, remove the 2 screw covers using a long flat plate such as a ruler
wrapped in a cloth and remove 3 screws fixing the front grille.
"6.2.1 To remove the front
"6.2.2 To open the service
4
panel" [ 23] and
4
cover" [ 24].
CTXM-A, FTXM-A, ATXM-A
Daikin room air conditioner
4P518023-17P – 2023.06