Advertisement
Plumbing Diagram
Plumbing the air line to the tank
Bad Cut
Use a flathead screwdriver to pry
the filter housing apart. You can
insert the flat end of the
screwdriver into seam, where the
arrow is
Make sure the 5/16" lines are equal length!
Good Cut
Ensure each air line is fully seated over the
compression fitting before tightening the nut
down over it. If the line is not fully seated over
the barb, it can slip off the fitting even with the
nut in place. Hold the line in place and use a
wrench to tighten the compression ferrule down.
Remove the old filter element
from the housing. Insert the new
element into the center so that
the white portion of the filter lines
up with the plastic tabs. Replace
the cover back over the housing,
lining the tabs up on the sides of
the cover.
The compressor filter must be
changed out every 2-3 months,
otherwise the compressor will
start to pull in dirt/dust and wear
prematurely.
Page 7
Advertisement
