Advertisement
Safety Tips and Important Information
IMPORTANT SAFETY INSTRUCTIONS
Caution: To prevent the risk of electric shock or electrocution:
• Do not disassemble any electrical components of this horn kit (air compressor, air valve, pressure switch).
• Do not attempt repairs or modifications of any component. Please refer to qualified service agencies for all
service and repairs.
• Do not operate any component where it can fall or be submerged into water or any kind of liquid.
• Do not reach for any component that has fallen or been submerged into water or any kind of liquid.
• Use the included components with 12 volt DC systems only.
• Do not leave the air system unattended during use.
WARNING: To prevent injury:
• Never allow children to operate the compressor or air horn. Use close supervision when operating this
equipment near children or animals.
• The air compressor will become very HOT during and immediately after operation. Do not touch any part of
the compressor with your bare hands during or immediately after use.
• Do not use this product near open flames or explosive materials or where aerosol products are being used.
• Do not operate this product where oxygen is being administered.
• Do not pump anything other than atmospheric air.
• Never use this product while sleepy or drowsy.
• Do not use any tools or attachments with the supplied air source unit without first determining maximum air
pressure for that tool or attachment.
• Never point any air nozzle or air sprayer toward another person or any part of your body.
• The included compressor is equipped with an automatic reset thermal protector and can automatically
restart after the thermal protector resets. Always cut off power source when thermal protector becomes
activated.
• Use only in well ventilated areas.
• Do not sound the air horn(s) in close proximity to another person's or your own ear(s).
• Do not fill the included air tank above 150 PSI. Doing so may result in death or serious injury.
• Disconnect the battery negative cable before doing anything. Failure to disconnect this terminal can lead to
damaged electrical components.
• Use eye protection when operating drills or other power tools during the install.
• Ensure the parking brake is engaged before you get underneath the vehicle.
• Do not wire the system without the fuse holder.
• Do not allow the compressor to run when the vehicle is off.
www.hornblasters.com
support@hornblasters.com
Page 3
Advertisement
