Advertisement
Preparing For the Install
Recommended Install Locations for Your Car (Compressor)
• The trunk of your car/sedan/suv is a great spot for this air source kit. The trunk keeps the compressor
out of the weather and is one of the best install locations for the compressor/tank combo.
• The engine bay can also be used as an install location for the air source. If you have enough room to
mount the air source without getting too close to the engine, this will work just fine. Do not mount the
compressor to close to engine. If the compressor gets too hot, it will not run.
• If you decide to mount the compressor outside the car make sure it won't get submerged if you go
through a large puddle! It can get wet but you cannot submerge the system.
Check out the install photos below, these are two examples of installs in the rear storage area of a car with a sub.
Recommended Install Locations for the Horns
• These horns will sound their best when facing down towards the ground, or towards the front of the vehicle
(these can face forward!) We typically see these mounted behind the front bumper, ahead of the radiator on
most vehicles. (see picture below, to the right)
o If you opt to install the horns in the front grille, make sure that the opening at the end of each bell is not
blocked or covered. Make sure to leave some room for airflow to your radiator!
Horns installed
underneath a car
Horns installed
in the front
grille of a car
Page 5
Advertisement
