Configuring Static Routes - NETGEAR ProSafe FVS338 Reference Manual

Reference Manual for the ProSafe VPN Firewall 50 FVS338
Click Apply.
4.
Note: All incoming traffic to that IP address will be sent to the selected PC. Out-going traffic from
the selected PC will use the IP address you entered, not the default WAN IP address. No firewall
protection is available. Use this feature at your own risk.
If you only have one Internet IP address, you cannot use the Multi-DMZ feature. You can only use
the Default DMZ Server setting (see "Exposed Host (Software DMZ)" on page 6-7).

Configuring Static Routes

Static Routes provide additional routing information to your firewall. Under normal
circumstances, the firewall has adequate routing information after it has been configured for
Internet access, and you do not need to configure additional static routes. You must configure
static routes only for unusual cases such as multiple firewalls or multiple IP subnets located on
your network.
From the Main Menu of the browser interface, under Advanced, click on Static Routes to view the
Static Route menu, shown below.
Figure 6-6. Static Routes Summary Table and Add screens
6-10 LAN Configuration
January 2005