NETGEAR ProSafe FVS338 Reference Manual page 46

Reference Manual for the ProSafe VPN Firewall 50 FVS338
Connect to the Internet.
3.
Figure 4-1: Setup Wizard
You are now connected to the VPN firewall. If you do not see the menu above, click the
a.
Setup Wizard link on the upper left of the main menu.
Choose NAT or Classical Routing. NAT automatically assigns private IP addresses
b.
(192.168.0.x) to LAN connected devices. Classical routing lets you directly manage the IP
addresses the FVS338 uses. Classical routing should be selected only by experienced
users.
Click Next and follow the steps in the Setup Wizard for inputting the configuration
c.
parameters from your ISP to connect to the Internet.
Note: If you choose not to use the Setup Wizard, you can manually configure your
Internet connection settings by following the procedure
Internet Connection" on page
Unless your ISP automatically assigns your configuration automatically via DHCP, you
will need the configuration parameters from your ISP as you recorded them previously in
"Worksheet for Recording Your Internet Connection Information" on page 4-3
When the VPN firewall successfully detects an active Internet service, the VPN firewall's
d.
Internet LED goes on. The Setup Wizard reports which connection type it discovered, and
displays the appropriate configuration menu. If the Setup Wizard finds no connection, you
will be prompted to check the physical connection between your VPN firewall and the
cable or DSL line.
The Setup Wizard will report the type of connection it finds. The options are:
e.
4-6
4-14.
Connecting the FVS338 to the Internet
January 2005
"Manually Configuring Your