Table of Contents
Advertisement
Reference Manual for the ProSafe VPN Firewall FVS114
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVS114
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
covered by these VPNC-recommended parameters, refer to
Virtual Private
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
Log in to the FVS114 at its LAN address of
1.
admin and password of password. Click the VPN Wizard link in the main menu to display
this screen. Click Next to proceed.
Figure 5-4: VPN Wizard start screen
Fill in the Connection Name and the pre-shared key, select the type of target end point, and
2.
click Next to proceed.
Note: The Connection Name is arbitrary and not relevant to how the configuration functions.
5-6
Table 5-1 on page
Networking" to set up the VPN tunnel.
202-10098-01, April 2005
5-4. If you have special requirements not
Chapter 6, "Advanced
http://192.168.0.1
with its default user name of
Basic Virtual Private Networking
Advertisement
Table of Contents
Troubleshooting
