Now, Configure The Fvs114 For Internet Access - NETGEAR ProSafe FVS114 Reference Manual

Reference Manual for the ProSafe VPN Firewall FVS114
Power
Figure 3-4: Status lights
Check the VPN firewall router status lights to verify the following:
d.
• PWR: The power light should turn solid green. If it does not, see
Tips" on page
• TEST: The test light blinks when the firewall is first turned on then goes off. If after
two minutes it is still on, see
• INTERNET: The Internet LINK/ACT light should be lit. If not, make sure the Ethernet
cable is securely attached to the VPN firewall router Internet port and the modem, and
the modem is powered on.
• LOCAL: A LOCAL light should be lit. Green on the 100 line indicates your computer
is communicating at 100 Mbps; off on the 100 line indicates 10 Mbps. If a LOCAL
light is not lit, check that the Ethernet cable from the computer to the firewall is
securely attached at both ends, and that the computer is turned on.

Now, Configure the FVS114 for Internet Access

From the Ethernet connected PC you just set up, open a browser such as Internet Explorer or
1.
Netscape® Navigator.
3-4
Test Internet
3-6.
"Troubleshooting Tips" on page
202-10098-01, April 2005
Local Port 4
"Troubleshooting
3-6.
Connecting the Firewall to the Internet