NETGEAR ProSafe FVS114 Reference Manual page 81

Repeat for the FVS114 on LAN B. Pay special attention and use the following network
6.
settings as appropriate.
• WAN IP of the remote VPN gateway (e.g., 14.15.16.17)
• LAN IP settings of the remote VPN gateway:
— IP Address (e.g, 192.168.0.1)
— Subnet Mask (e.g., 255.255.255.0)
— Preshared Key (e.g., 12345678)
Use the VPN Status screen to activate the VPN tunnel by performing the following steps:
7.
Note: The VPN Status screen is only one of three ways to active a VPN tunnel. See
"Activating a VPN Tunnel" on page 5-26
Open the FVS114 management interface and click on VPN Status under VPN to get the
a.
VPN Status/Log screen
Figure 5-30: VPN Status/Log screen
Click on VPN Status
b.
(Figure 5-31). Click on Connect for the VPN tunnel you want to activate.
Basic Virtual Private Networking
Reference Manual for the ProSafe VPN Firewall FVS114
for information on the other ways.
(Figure 5-30).
(Figure 5-32) to get the Current VPN Tunnels (SAs) screen
202-10098-01, April 2005
5-25