Table of Contents
Advertisement
With the VPN firewall router in its factory default state, your browser will automatically
display the NETGEAR Smart Wizard Configuration Assistant welcome page.
Figure 3-5: NETGEAR Smart Wizard Configuration Assistant welcome screen
Note: If you do not see this page, type http://www.routerlogin.net in the browser address bar
and press Enter. If you still cannot see this screen, see
Assistant" on page
If you cannot connect to the VPN firewall router, verify your computer networking setup. It
should be set to obtain both IP and DNS server addresses automatically, which is usually so.
For help with this, see
Resource CD.
Click OK. Follow the prompts to proceed with the Smart Wizard Configuration Assistant to
2.
connect to the Internet.
Click Done to finish. If you have trouble connecting to the Internet, see
3.
Tips" on page 3-6
Note: The Smart Wizard Configuration Assistant only appears when the firewall is in its factory
default state. After you configure the VPN firewall router, it will not appear again. You can always
connect to the firewall to change its settings. To do so, open a browser such as Internet Explorer
and go to http://www.routerlogin.net. Then, when prompted, enter admin as the user name and
password for the password both in lower case letters.
You are now connected to the Internet!
Connecting the Firewall to the Internet
Reference Manual for the ProSafe VPN Firewall FVS114
3-9.
Appendix D, "Preparing Your Network
to correct basic problems.
202-10098-01, April 2005
"How to Bypass the Configuration
or the animated tutorials on the
"Troubleshooting
3-5
Advertisement
Table of Contents
Troubleshooting
