Changing The Administrator Password; Diagnostics - NETGEAR ProSafe FVS114 Reference Manual

Reference Manual for the ProSafe VPN Firewall FVS114
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the reset button on the rear panel of the firewall. See "Restoring the Default
Configuration and Password" on page 9-7.

Changing the Administrator Password

The default password for the firewall's Web Configuration Manager is password. NETGEAR
recommends that you change this password to a more secure password.
From the main menu of the browser interface, under the Maintenance heading, select Set Password
to bring up this menu.
Figure 7-7: Set Password menu
To change the password, first enter the old password, and then enter the new password twice. Click
Apply. To change the login idle timeout, change the number of minutes and click Apply.

Diagnostics

You can use the Diagnostics page to perform various diagnostics. For normal operation, these are
not required.
From the main menu of the browser interface, under the Maintenance heading, select Diagnostics
to bring up this menu.
7-8 Maintenance
202-10098-01, April 2005