Advertisement
Control Panel
Operation
1. Press the POWER button to turn the unit On or Off. After it is switched on, the
dehumidifying function will start immediately. The power indicator light next to
'DEH' will light up. When the compressor stops, the light will flash.
2. Press the SPEED button to switch the fan speed. The fan speed can be switched
between high and low. Please note that in the COMFORT setting ('AU'), when the
room temperature is above 27°C, the fan speed is fixed on high.
3. Press the UP and DOWN buttons to set your required humidity, between 30-90%.
The CONTINUOUS ('CO') setting will be the default. After 90%, you can also select
the COMFORT ('AU') setting. The CONTINUOUS and COMFORT settings are further
explained in the functions section of the manual. Press these buttons at the same
time to change the display between the room temperature and the humidity. The
indicator light for C° will switch on when showing the temperature, and the %
indicator light will switch on when showing the humidity levels.
4. Press the TIMER button to set the timer on the unit. When the device is On, press
this button to set the timer for scheduled shut down. When the device is Off, press
this button to set the timer for a scheduled switch on. The timer ranges between
1-24 hours and increases in increments of 1 hour with each click. When the timer is
set to turn on the device, the timing on the device will display. When the timer is
set to turn off the device, the humidity will display after 5 seconds.
5. Press the MODE button to set your desired mode. There are three modes, being
DEHUMIDIFY (DEH), FAN and DRY (Laundry).
6. Press the WIFI button for 5 seconds to connect the device to Wi-Fi. The indicator
14
Advertisement
