Tools Required For Assembly - Agri-Fab 45-0410 Owner's Manual

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2) 7/16" Wrenches
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton.
Lay out all parts and hardware and identify using the
illustrations on page 3.
1. Assemble vinyl caps onto the ends of the R.H. and L.H.
Hitch Tubes. See figure 1.
2. Assemble the R.H. Hitch Tube to the spreader frame
tube using two 1/4" x 1-3/4" hex bolts and 1/4" nuts. Do
not tighten yet. Repeat for L.H. Hitch Tube. See figure
1.
VINYL CAP
FIGURE 1
3. Assemble the Hitch Control Tube between the Hitch
Tubes using two 1/4" x 1-1/4" hex bolts and 1/4" nuts.
Tighten all bolts and nuts . See figure 2.
FIGURE 2
1/4" NUT
1/4" x 1-3/4"
HEX BOLT
1/4" NUT
1/4" x 1-1/4"
HEX BOLT
4. Assemble the Hitch Brackets to the Hitch Control Tube
using two 1/4" x 1-1/4" hex bolts and 1/4" nuts. Tighten.
See figure 3.
5. Assemble the hitch pin through the hitch brackets and
secure with the 1/8" hair cotter pin. See figure 3.
FIGURE 3
6. Assemble the vinyl cap onto the Hitch Control Tube. See
figure 4.
7. Assemble the Control Cable to the Hitch Control Tube
using the carriage bolt and nylon wing nut. See figure
4.
FIGURE 4
4
HITCH PIN
1/4" x 1-1/4"
HEX BOLT
1/4" NUT
HAIR COTTER PIN
CARRIAGE BOLT
VINYL CAP
NYLON
WING NUT