Advertisement
Cold Thermostat
This shows the correct and factory default set
point. Although adjustment is possible (clockwise
reduces the temperature and anti-clockwise
increases the
water temperature), this correct default setting is to
ensure optimum performance and reliability.
Unauthorised alternative settings could cause
technical issues and invalidate the warranty.
Chilled
Chilled On/Off Switch: at upper rear of machine,
switches cooling operation on/off.*
Cold Thermostat: at rear of machine.
Chilled Button: Press to dispense cold water.
Chilled LED: Indicates chilling application is
switched on.
10A Fuse: On rear of machine, integral with IEC
socket.
*All Direct Chill variants incorporate an auto-fill
system
Ambient
Ambient Button: Press to dispense ambient water.
Floorstanding Version
Sparkling
Carbonation On/Off switch: Switches sparkling
operation on/off.
Sparkling Button: Press to dispense sparkling water.
Sparkling LED: Indicates sparkling application is
switched on.
Hot
Hot On/Off Switch: The hot water heating mode
is controlled by a switch on the back of the unit,
next to the cooling mode switch.
Hot Thermostat: regulated by a pre-set, non-
adjustable sensor on the tank.
Hot Button (incorporates safety lock): Press once to
unlock. Press again to dispense hot water. (Note:
Machine will revert to locked after 5 seconds if
dispense is not activated.)
Hot LED: Indicates hot application is switched on.
Advertisement
