ADVANCED
Advanced > WAN
Clicking on the 'Advanced' menu displays the following:
This screen provides a summary of the current WAN interfaces you have confi gured. If you have connected
the NB9/NB9W to ADSL through the ADSL Quick Setup interface, details of the connection will be
summarised here.
Setting up a WAN profi le goes through a set of steps which establishes connection parameters covering the
following:
Field
VPI/VCI
Con. ID
Category
Service
Interface
Protocol
IGMP
NAT
Firewall
QoS
State
Once settings are entered, click Save. Connection status can be checked under Status>Diagnostics.
Choosing a WAN Profi le
In the event that you wish to set up several connection profi les on your NB9/NB9W for use in different
locations OR with different ADSL services
•
click 'Add' to add the next connection profi le
•
Repeat set up steps above
52
Means
Always 8/35 in Australia
Sequence number of connection (e.g. 1,2...)
ATM Service Category; leave as default
Name of connection: give this a name you will recognise (e.g. ISP
name)
Current WAN interface name
Bridge or Router Mode
Enable/Disable IGMP proxy
Enable/Disable NAT (leave enabled unless advised otherwise by
tech support)
Enable/Disable Firewall (leave enabled unless advised otherwise by
tech support)
Enable/Disable QoS; enable if VoIP services are being used.
Enable/Disable this WAN connection
NB9/NB9W ADSL2+ VoIP Router
YML790 Rev1