Table of Contents
Advertisement
1
4
1. Power on, all digits display 1 second.
2. Software revision displays 1.5 seconds.
3. Normal display indicates mode of operation and inlet water
temperature from "Pool" or "Spa".
4. Press MODE button to Select "Pool" or "Spa" temperature setpoint, press UP
or DOWN arrows to adjust temperature between 50ºF (10ºC) minimum and
104ºF (40ºC) maximum.
5. Blower "Pre-Purge" for 45 seconds, Spark and Ignite.
6. Heater temperature setpoint, water temperature and "Heating" is displayed.
2
5a
Start-Up Operating Displays
3a
5b
3b
6
17
Advertisement
Table of Contents
