Transducer Block Information - BEAMEX MC5-IS User Manual

Transducer Block Information

To open the Transducer
Block Information win-
dow, press
D
B
needed
3
Information
The contents of this win-
dow depend on the con-
nected instrument. This
is because Transducer
Block parameters vary
from instrument to in-
strument.
Normally you do not need to edit any of the parameters shown
here. The most likely one in need of editing is the unit. If MC5-
IS supports the unit, it is shown as in the example picture
above. If MC5-IS does not support the unit, a numeric value is
shown instead of the unit.
Fieldbus and MC5-IS' Basic Mode
Menu
/ and
Window 2 Setup
/
Transducer Block
/
.
Notes.
To quickly browse through the list of parameters use MC5-
and keys.
IS'
When editing a unit field, MC5-IS displays the numeric
code for the unit (the code is as defined in fieldbus specifi-
cations). Please refer to Appendix 1, Codes in Profibus
PA Profile Version 3.0 on page 34, Appendix 2, Codes
in Profibus PA Profile Version 2.0 on page 39, or the in-
strument's manual to see which numeric code corresponds
to which unit.
Several other Transducer Block parameters are also
edited using a numeric code.
User Guide – MC5-IS Fieldbus Option for PROFIBUS PA
3 0 . 0 3 . 2 0 0 7
P R I M A R Y _ V A L U E _ T Y P E
P R I M A R Y _ V A L U E _ R A N G E
M O D E _ B L K
, if
C A L _ P O I N T _ H I
C A L _ P O I N T _ L O
C A L _ M I N _ S P A N
C A L _ U N I T
S E N S O R _ R A N G E
S E N S O R _ S N
S E N S O R _ C A L _ M E T H O D
S E N S O R _ C A L _ L O C
° C
C l o s e
1 3 : 5 1
T R A N S D U C E R B L O C K
E d i t
23