Appendix A Replacing The Name Plaque - Raymarine AXIOM 2 PRO Installation Instructions Manual

Appendix A Replacing the name plaque

The Raymarine name plaque located below the Back button on Axiom® 2 Pro
displays can be replaced with an OEM-branded name plaque. OEMs can
order bulk packs (qty: 40) of blank name plaques (part number: A80724),
which can then have the OEM branding printed on them.
Follow the steps below to replace the name plaque.
Important:
Do NOT use metallic or sharp objects to remove the keypad or infill piece,
as this could damage the keypad and/or display.
1. Open the card reader door.
2. Axiom 2 Pro 12 and Axiom 2 Pro 16 only — Using a plastic pry tool, lever
the infill piece located below the lower keypad against the small plastic
protrusion. This will release the infill piece from the display.
3. Using a plastic pry tool, lever the bottom of the keypad against the small
plastic protrusion to release the keypad from the display.
4. Using a plastic pry tool, lever the bottom of the name plaque
approximately one third of the way along the bottom of the name plaque
to release it from the display.
Replacing the name plaque
5. Insert one edge of the new name plaque and then apply pressure to the
opposite side until it clicks into position.
6. Insert one edge of the keypad and then bend the keypad slightly in the
middle to allow the other edge to be inserted into the opposite side.
7. Axiom 2 Pro 12 and Axiom 2 Pro 16 only — Insert one edge of the infill
piece and then bend the infill piece slightly in the middle to allow the
other edge to be inserted into the opposite side.
8. Close the card reader door.
Replacement name plaque printing specification
Specification
Base material:
Paint:
Logo printing method:
Logo ink requirement:
Black PC / ABS
Matt black
Pad printing
UV resistant ink
117