Chapter 1 Important Information; Safety Warnings; Product Warnings; Regulatory Notices - Raymarine AXIOM 2 PRO Installation Instructions Manual

CHAPTER 1: IMPORTANT INFORMATION

Safety warnings

Warning: Product installation and operation
• This product must be installed and operated in accordance
with the instructions provided. Failure to do so could result
in personal injury, damage to your vessel and/or poor
product performance.
• Raymarine highly recommends certified installation by
a Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Register your warranty on the Raymarine website:
www.raymarine.com/warranty
Warning: High voltage
This product contains high voltage. Adjustments require
specialized service procedures and tools only available to
qualified service technicians. There are no user serviceable
parts or adjustments. The operator should never remove the
cover or attempt to service the product.
Warning: Switch off power supply
Ensure the vessel's power supply is switched OFF before
starting to install this product. Do NOT connect or disconnect
equipment with the power switched on, unless instructed in
this document.
Warning: Potential ignition source
This product is NOT approved for use in hazardous/flammable
atmospheres. Do NOT install in a hazardous/flammable
atmosphere (such as in an engine room or near fuel tanks).
10

Product warnings

Caution: Product weight
• Refer to the technical specification for your product to
ensure the intended mounting surface is suitable to bear
its weight.
• 2 people may be required for installation of larger / heavier
products.
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants.
Do NOT use sealants containing acetate or silicone, which can
cause damage to plastic parts.

Regulatory notices

Regulatory e-Label

All the applicable regulatory and compliance standards for your product
are listed in electronic format in a regulatory "e-label" document, which can
be viewed on your product's display.
To access the Regulatory e-Label for your product:
From the Homescreen: [Settings > Getting Started > Regulatory Approvals]

Declaration of Conformity

FLIR Belgium BVBA declares that the products listed below are in compliance
with the EMC Directive 2014/53/EU:
• Axiom® 2 Pro 9 S multifunction display, part number E70653
• Axiom® 2 Pro 9 RVM multifunction display, part number E70654
• Axiom® 2 Pro 12 S multifunction display, part number E70655
• Axiom® 2 Pro 12 RVM multifunction display, part number E70656
• Axiom® 2 Pro 16 S multifunction display, part number E70657
• Axiom® 2 Pro 16 RVM multifunction display, part number E70658