Quantum DXi6900-S Installation Manual page 25

Installing the DXi6900-S System in the Rack
3. Install the end caps on either side of the module by inserting the top of the end cap first and then
snapping the bottom into place.
Install the end cap with the indicator icons to the left of the module, and install the end cap with the drive
numbers to the right of the module.
Note: To remove the Array or Expansion module, remove the screws and slide the module out of the
rack.
Figure 15: DXi6900-S Array or Expansion Module Installation
2
1
Item Description
1 10-32 x 3/4 in. screw and nylon washer
2 Front of Array or Expansion Module
Installing the DXi6900-S Node
Installing the DXi6900-S Node Rack Mounting Rails
1. Position the left and right rail end pieces labeled FRONT facing inward, and orient each end piece to
seat in the holes on the front side of the vertical rack flanges (see Figure 16 on the next page).
2. Align each back end piece in the bottom and top holes of the desired U spaces.
3. Engage the back end of the rail until it fully seats on the vertical rack flange and the latch clicks into
place. Repeat these actions to position and seat the front end piece on the vertical rack flange.
Quantum DXi6900-S Installation Guide 25