Energy Saving - LAVAZZA EP MAXI 1050 DUAL Instructions Manual

LOADING THE HYDRAULIC CIRCUIT
When the machine is first switched on, or if it has
not been used for a long time, or if all the water in
the tank is completely used up, you must carry out
the hydraulic circuit loading operation as explained
below.
Rotate the steam/hot water arm until it is com-
1
pletely outside the machine. Position a container
or a cup under the steam arm. Activate the dis-
pensing of hot water by turning the knob clock-
wise. Wait for the water flow to be continuous
for at least 5 seconds, then stop dispensing.

ENERGY SAVING

After a period of inactivity, the machine will go
1
into energy saving mode and the on light will
flash.
To re-start the machine lift and lower the car-
2
tridge load lever.
The machine is ready for use when it emits an
3
acoustic signal and the power light remains lit.
PREPARING THE MACHINE
PROGRAMMING AND PREPARING
COFFEE
The machine has two buttons for dispensing two
different pre-programmed servings of coffee. These
quantities can be modified according to the user' s
tastes by utilising the programming option.
Long coffee
dispenser
button
R egulating the dispensing spout:
Espresso coffee: dispensing spout out,
facing down.
Large cup: dispensing spout back,
facing up.
Regulating the cup-support rack:
Espresso coffee: Rack up, rotated 180°.
Large cup: Rack down (standard position).
Only Lavazza ESPRESSO POINT MAXI cartridges
may be inserted in the cartridge slot.
E N
Espresso coffee
dispenser button