JEI MAGBEAST HM200T Operator's Manual page 3

[1] SPECIFICATIONS OF
Maximum hole cutting capacity in .2/.3C steel =
Motor Unit
Voltages
Normal full load output
Magnet Size
Magnet Force at 20°C with
25mm minimum plate thickness
The use on any material less than 25mm thick will
progressively reduce the magnetic performance. If
possible, substitute material should be positioned
under the magnet and work piece to equate to a
suitable material thickness. If this is not possible, an
alternative secure method of restraining the machine
MUST be used.
Overall Dimensions
Height - maximum extended
Height - minimum
Width (including Hand wheel)
Length Overall (including Guard)
Stroke
Net Weight
Maximum hand/arm vibration magnitude
(measured at handle during operation in
accordance with ISO5349, using a 22mm cutter
through 13mm MS plate)
Estimate of likely daily vibration exposure.
Operation 30 holes @ 2 minute/hole.
Average noise level during cutting at operator's
ear position.
3 | P a g e
MAGBEAST HM200T DRILLING MACHINE
MAGBEAST HM200T
200mm dia. x 75mm deep
Tapping up to M52
230v/60Hz 110v/50-60Hz
2850 W
295 x 140 x 70 mm
2,200kg/26,800N
955mm
730mm
280mm
455mm
330mm
52kgs
0.82 m/s²
0.29m/s² A(8)
89dB(A)