Table of Contents
Advertisement
cutter breakage
5) )
Excessive
cutter wear
8 |
P a g e
cutter
Incorrectly re-sharpened
or worn cutter
Cutter skipping
Slide-ways
adjustment
Cutter
not
attached
tightly to arbor
Insufficient use of cutting
oil or unsuitable type of
oil
Incorrect speed selection. Select appropriate speed.
Incorrectly re-sharpened
cutter.
Insufficient or spasmodic
cutting pressure
thoroughly and replace
Always have a new cutter on
hand to refer to for correct tooth
geometry,
instruction sheet
See causes and remedies (2)
need
Tighten slide-way
Retighten
Fill arbor with an oil of light
viscosity and check to be sure oil
is being metered into cutter when
pilot is depressed.
check pilot groove and arbor
internally for dirt or apply oil
externally.
Even a small amount of oil is very
effective.
Refer to instructions and a new
cutter for proper tooth geometry
Use sufficient steady pressure to
slow the drill down. This will
result in optimum cutting speed
and chip load.
MAGBEAST HM200T
together
with
If not,
Advertisement
Table of Contents
