NEC Express5800/R120h-1M Manual page 47

Hide thumbs Also See for Express5800/R120h-1M:

● Notes of using SAS controller (N8103-184)

When using N8103-184, "Status" of iLO Web interface [System Information] - [Storage] - [Storage Controller] is might

display to "Unknown", but it does not affect server operation and SAS Controller operation.

● About Smart Storage Battery

Smart Storage Battery is indicated with Energy Pack on the RBSU menu. Please paraphrase.

● About EXPRESSBUILDER Help

If the EXPRESSBUILDER help is different from Maintenance Guide, do not use the help but the guide.

● Precautions on data backup

There are cases that the device connected to FC controller may be misrecognized as an internal micro SD card slot, or

that the empty internal micro SD card slot is misrecognized during auto backup with NEC Storage causing a pop-up error

message and suspension of backup.

Due to such causes, there may be cases that data backup cannot be normally performed.

To prevent this to happen, the setting of this product is modified at the factory for disable internal micro SD card slot by

the following procedure.

There is no influence on usual server operation since internal micro SD card slot is not to be used.

From System Utilities > BIOS/Platform configuration (RBSU) menu > System Options > USB Options, set Internal

SD Card Slot to Disabled.

● About FCoE function in N8104-173/177

The FCoE function (Fibre Channel over Ethernet) isn't supported with this product as NEC.

The FCoE function is enabled in N8104-173 in spite of the LOM firmware version, in N8104-177 with Family Firmware

Version after 8.35.43.

It is recognized as the FCoE device on the OS, but when not using it from OS and drivers it does not cause any problem

for the operation.

Please ignore detection of the following device.

-HPE 533FLR-T FCoE Device

-HPE 622FLR-SFP28 FCoE Device

● About DisplayPort Connector

DisplayPort Connector at the front is not supported.

● About Wake On LAN function in N8104-173

When using Wake On LAN function in N8104-173 (Dual Port 10GBASE-T LOM Card), use PORT1 for this function..

- 47 -

Express5800/r120h-2m