Remounting - Flowserve Limitorque Accutronix MX Maintenance & Spare Parts Manual

4.5.3 Remounting

STEP 7
Check that bearing (#13-8) is correctly in place in the
actuator housing.
MX-40 is slip fit in housing (7a).
MX-85 is press fit in housing (7b).
STEP 8
If previously removed, install handwheel worm gear
assembly (#12). (See Section 4.14.2 for remounting
procedure for MX-40.)
(See Section 4.16.2 for remounting procedure for
MX-85 & 140).
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
Flow Control Division
Limitorque Actuation Systems
Mechanical Assemblies
7a
13-8
7b
8
Handwheel Worm
Gear Adapt. (12-1)
4-23