Table of Contents
Advertisement
Remount all removed subassemblies according to the remounting instructions in the following order:
1. Terminal block (subassembly #15). (See Section 5.4.2.)
2. Control module (subassembly #8). (See Section 5.2.2.)
3. Accutronix control panel (subassembly #7). (See Section 5.1.2.)
4. Motor (subassembly #4). (See Section 4.1.2.) If the motor voltage has changed, please see Section
5.2.3., Step 10 to ensure the voltage jumper on the power board is located in the proper slot.
5.6 Encoder (MX-05, 10, 20, 40, 85 & 140)
Table 5.5 – Encoder Parts List
Part Number
1-6
1-36
6-11
6-24
Figure 5.15 – Encoder
6-11
(MX units with Drive
Speed I.D. 3 thru 8 require
standard input gear).
Reference table below
to determine your actuator
requirements.
6-24
(MX units with Drive
Speed I.D. 1 or 2 require
optional input gear).
Reference table below
to determine your actuator
requirements.
Table 5.6 – Encoder Drive Sleeve Speed
Drive Sleeve Speed I.D.
50 Hz. RPM
60 Hz. RPM
NOTE: MX units with Drive Speed I.D. 1 or 2 require an optional input gear. Reference the
Output RPM block located on the MX nameplate and cross-reference in table above to
determine the unit Drive Speed I.D.
NOTE 1: MX-85 & 140 only.
NOTE 2: N/A MX-85 & 140.
Accutronix MX Maintenance & Spare Parts Manual
Description
Encoder Assembly
Socket Head Cap Screw (M4x16)
Input Gear, 78-tooth (I.D. 3 through 8)
Input Gear, 69-tooth (I.D. 1 or 2)
1-36
1
2
3
2
15
22
33
2
18
26
40
130-12000 Revision B • November 2002
Limitorque Actuation Systems
Qty.
1
3
1
1
1-6
4
5
6
7
1
43
65
84/110
127/143
1
52
77
100/131
155/170
Flow Control Division
Electronic Assemblies
8
1
2
165
1
2
200
5-27
Advertisement
Table of Contents
