Remounting - Flowserve Limitorque Accutronix MX Maintenance & Spare Parts Manual

Electronic Assemblies

5.8.2 Remounting

STEP 3
Work the three connectors through the hole/slot in the housing. (Hole/slot is located in the motor
cavity next to the worm shaft bore.) Thread the three connectors through the housing into the controls
compartment cavity until the lead seal fits completely into the hole/slot in the housing.
3a
STEP 4
Remount all removed subassemblies according to the remounting instructions in the following order.
1. Contactor assembly (subassembly #8). (See Section 5.5.1)
2. Control module (subassembly #15). (See Section 5.4.1)
3. Accutronix control panel (subassembly #7). (See Section 5.1.1)
4. Motor (subassembly #4). (See Section 4.1.1)
5-34 Accutronix MX Maintenance & Spare Parts Manual
Limitorque Actuation Systems
3b
Rotate
CCW 90˚
This side down
3c
130-12000 Revision B • November 2002
Flow Control Division
Top