Skoda Octavia II 2004 Workshop Manual page 30

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
10 - 23 Nm
11 - AC generator
❑ removing and installing ⇒ Electrical System ⇒ Rep. gr. 27
❑ to facilitate positioning, push the threaded bushings of the fixing screws on the generator backwards
slightly
12 - 45 Nm
❑ Observe tightening sequence
13 - Fitting sleeve
❑ 2 pieces
❑ pay attention to correct fit in the holder
14 - 25 Nm
15 - AC compressor
16 - V-ribbed belt
❑ mark the direction of rotation with chalk or a felt-tip pen before removing
❑ check for wear
❑ do not kink
❑ Removing ⇒ page 25
❑ installing ⇒ page 26
Bolts at bracket for auxiliary units - tightening sequence
(
Tightening torque of guide pulley - vehicles with small engine
support (only for vehicles with engine code BKD, AZV)
Unscrew screw -arrow- without inside thread.
•
Tightening torque: 40 Nm + torque a further 90° (
24
Rep. gr.13 - Crankshaft group
⇒ page 24
1
/ 4 turn).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�