Table of Contents
Advertisement
5. EMR/LIS protocol menu
By default, the EMR protocol is
disabled. Tap
to show the
different protocols and choose
the desired one.
5.3 TEXT/PLAN RS232/USB
protocol
The
two
options,
RS232
USB
or
are the same, except
for the type of cable used for the
transfer.
Automatic transmission
If
Yes
, test results will automatically be
transferred to the host immediately
after measurement.
The options to the right define which
type of data will be transmitted. They
can be On/Off as required.
PI MCI-EUR Rev 05
5.1 ASTM TCP/IP protocol
There are several options to
consider for the ASTM TCP/IP
protocol:
Automatic transmission
If
Yes
, test results will automatically
be
transferred
immediately after measurement.
Enter the
the desired host below.
Send ordered only
Setting
(only
available
transmission
transmit only results requested by
the host.
Receiving Facility
Under
of the LIS/HIS can be entered.
Tap
5.4 E-Mail protocol
TEXT/PLAIN
For the E-Mail option enter a safe
and specific E-Mail address to
send the results to.
Note:
is set to
blank there will be a prompt to
enter an address every time
results are transferred.
Tap
is set to
to
the
host
IP
and
Port
number of
Yes
to
Automatic
if
Yes
is set to
) will
, the name
to confirm settings.
If the E-Mail section is left
to confirm settings.
5.2 HL7 TCP/IP protocol
HL7 TCP/IP
The options for the
protocol are as follows:
Automatic transmission
If
Yes,
to
test
results
automatically be transferred to
the
host
immediately
measurement.
IP
and
Port
Enter the
the desired host below.
Please see the HL7 user manual
for details on the options for
Receiving Application and
Receiving Facility.
Tap
to confirm settings.
5.4.1 E-Mail Transfer
After tapping a transmit button (
on a single result or
list), there will be a prompt to set up
the E-mail account, from which the
results will be sent.
Setting up the E-mail account will
depend on the provider.
is set
will
after
number of
in the result
23 / 50
Advertisement
Table of Contents
