Proper Grounding - Saladax MyCare Insite User Manual

Always connect to the proper supply voltage. The power adapter voltage must comply with
the regulations cited in the technical specifications on page 48. Ensure the electrical
ground is correctly installed (page 15). Use only the power adapter provided to operate the
Analyser.

Proper Grounding

To ensure that the Analyser is properly grounded, use a 3-pole power outlet that includes neutral, hot
and ground sockets. The MyCare Insite must be connected to a power outlet with a 3-pole plug.
Illustration of different power outlets with grounding:
A certified electrician can confirm that the grounding meets requirements.
EMC Related Caution:
This equipment and/or system complies with the International Standard EN61326-1 for
electromagnetic compatibility for electrical equipment and/or system for measurement, control, and
laboratory use. However, an electromagnetic environment that exceeds the limits or levels stipulated
in EN61326-1, can cause harmful interference to the equipment and/or device or cause the equipment
and/or system to fail to perform its intended function or degrade its intended performance. Therefore,
during the operation of the equipment and/or device, if there is any undesired deviation from its
intended operational performance, the electromagnetic interference must be identified and resolved
before continuing to use the equipment and/or device. The following describes some common
interference sources and remedial actions:
1. Strong electromagnetic interference from a nearby emitter source such as an authorised
radio station or cellular devices:
Install the equipment and/or system at another location if it is interfered with by an emitter
source such as an authorised radio station. Keep the emitter source such as cellular devices
away from the equipment and/or system.
2. Radio-frequency interference from other equipment through the AC power supply of the
equipment and/or system:
Identify the cause of this interference and if possible remove this interference source.
3. Effect of direct or indirect electrostatic discharge:
PI MCI-EUR Rev 05
15 / 50