Trane S9V2B040U3PSBB Installer's Manual page 95

1. Remove the three inducer mounting screws.
2. Rotate inducer counterclockwise so that the inducer outlet aligns
with the exhaust vent outlet.
3. Reinsert and tighten screws to 30 in.-lbs. Do not overtighten.
1. Remove the pressure switch bracket assembly.
2. Remove the screw that holds PS2, rotate 90 degrees
counterclockwise, and reattach.
3. Reattach the pressure switch bracket assembly.
Note: The illustration shows PS2 in its final position after being
rotated.
18-CE01D1-1M-EN
F F u u r r n n a a c c e e C C o o m m b b u u s s t t i i o o n n A A i i r r E E x x h h a a u u s s t t O O p p t t i i o o n n s s
95