Victory 4x4 ARMREST INTERIOR MOLLE PANEL Install Instructions

2N D & 3RD GEN T UN DR A ( 0 7- 21) &

2N D GE N S EQ UOA ( 08 +)

AR MRE ST I NT ER I OR

MO LLE PAN EL

IN STALL INSTRU C TI ONS

Please read the mounting instructions below carefully before attempting to install.

Be sure to check out the install video on the product page, if available.

Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road

products. Be sure to rate and review our product online. If you have any questions or are missing parts, please

don't hesitate to call us at 269-459-8447!

Table of Contents

Need help?

Do you have a question about the ARMREST INTERIOR MOLLE PANEL and is the answer not in the manual?

Page 1 Be sure to check out the install video on the product page, if available. Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road products. Be sure to rate and review our product online. If you have any questions or are missing parts, please...
Page 2 I NCLU D E D HARDWARE Black Philips Head Black Nylon 1/2” OD 18-8 Stainless Steel 3/8” Long Spacer 3/4” Long Screw...
Page 3 I NCLU D E D PARTS...
Page 4 I NS TA LL ATI ON Start by lining up the panel up on the interior of your armrest on either the driver or passenger side, and center it visually to your liking, as shown below (passenger side). When the panel is lined up to your liking, then take a punch or a philips head screw driver and apply pressure to mark the four smaller mounting holes in the plastic.
Page 5 INSTA L L AT I ON Once the pilot holes are marked, you can remove the panel. Take the provided screws and start to thread them into the locations just marked in the plastic. Make sure not to punch too far through the plastic. You can also use a drill with a 1/16”...

Vgx46ccimp