Victory 4x4 TUNDRA Install Instructions Manual

Bedfront molle panel

2 ND AND 3 RD G EN T U N D RA

BEDFR ONT MOLLE PANEL

IN S TAL L INSTRU C T I O N S

Please read the mounting instructions below carefully before attempting to install.

Be sure to check out the install video on the product page, if available.

Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road

products. Be sure to rate and review our product online. If you have any questions or are missing parts, please

don't hesitate to call us at 269-459-8447!

Table of Contents

Need help?

Do you have a question about the TUNDRA and is the answer not in the manual?

Page 1 Be sure to check out the install video on the product page, if available. Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road products. Be sure to rate and review our product online. If you have any questions or are missing parts, please...
Page 2 I NCLU D E D HARDWARE 5/16”-18 5/16”-18 X 5/8" Serr. Flange Nut Button Head...
Page 3 I NC LU D E D PA RTS 2022 or Newer Brackets 07-21 Brackets...
Page 4 Tundra. Then tighten them partially back up but make sure the mounts are still able to move. Push the mounts against the front of the...
Page 5 I N S TA L L ATI O N Using a T-30 torx, remove the bolts along the top of the bed. If you have a model older than 2022, you my have to remove the rail and use a hammer to remove the slide pin in the middle (as shown below) that would prevent you from bolting it back down flush with the new brackets.
Page 6 I N S TA L L ATI O N After your brackets are in place, secure the assembled panel to the brackets in the orientation shown below using the provided button heads and nuts. Once the panel is loosely secure to the brackets, secure the panel to the previously installed lower mounts.
Page 7 I NS TA L L AT I O N 07-21 Models...