Victory 4x4 200 Series Install Instructions Manual

Monitor delete panel

Hide thumbs Also See for 200 Series:

2 0 0 S E RI E S & L X 57 0

MO N I TO R D E LE T E PA N EL

I N STAL L I NS T RU C T IO N S

Please read the mounting instructions below carefully before attempting to install.

Be sure to check out the install video on the product page, if available.

Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road

products. Be sure to rate and review our product online. If you have any questions or are missing parts, please

don't hesitate to call us at 269-459-8447!

Table of Contents

Need help?

Do you have a question about the 200 Series and is the answer not in the manual?

Page 1 Be sure to check out the install video on the product page, if available. Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great off-road products. Be sure to rate and review our product online. If you have any questions or are missing parts, please...
Page 2 I NCLU D E D HARDWARE 1/4”-20 x 3/4” Long Stainless Steel Button Head Screws...
Page 3 I NC LU D E D PA RTS...
Page 4 I N S TA L L ATI O N Start by removing the plastic cover panel behind the monitor, use a plastic pry tool or a flat head screw driver to pop the small bottom piece off, as shown below. Once the plastic piece is popped off, you need to disconnect the (2) wire harnesses that are now exposed.
Page 5 INSTA L L AT I ON Now that you have disonnected the wiring, you will need a 10mm socket to remove the (3) factory nuts holding the monitor in place. Be sure to support the monitor when removing the last nut as it is going to want to fall.
Page 6 INSTA L L AT I ON Once the bracket is secure and the wires are out of the way, take the provided button head bolts and use them to secure the face bracket to the mounting bracket, as shown in the orientation below, to complete your install.

Lx 570