Klarstein FUTURELIGHT SMART Manual page 45

Cleaning the inner casing
WARNING
Electrocution hazard! Switch off the unit before cleaning the inner
casing.
• Clean the inner casing with warm water and a grease cleaner (never use
aggressive cleaning agents, scouring powder or steel brushes).
Replacing the LED lighting
• If one of the lights is defective, the entire lighting must be replaced.
• Do not replace the lighting yourself. This should only be done by a qualifi ed
professional. Contact the customer service if you would like to have the LED
lighting replaced.
WARNING
Electrocution hazard! Make sure that the unit is switched off before
carrying out any maintenance work.
1
Open the light panel and remove the
fi lters (as shown in the illustration
for removing the grease fi lters).
Disconnect all cable connections that
are connected to the LED lighting.
Then loosen the two screws as shown
in the illustration.
2
Loosen the two axles.
Axle
EN
45