Measurement Stand-Alone With The Handheld - Bosch vivatmo pro Instructions For Use Manual

4.2

Measurement stand-alone with the handheld

Stand-alone measurements can be used when the handheld has no connection to the basestation.
The handheld must be out of range of the basestation or the basestation must be switched off.
The measurement procedure is guided by the handheld display and the LED on the upper side. Synchronize measurement
results of stand-alone measurements with the Vivatmo pro handheld by placing the switched on Vivatmo pro handheld in the
cradle of the Vivatmo pro basestation.
1. Use the ON/OFF button to activate your Vivatmo pro handheld.
You see all screen icons and the system performs a brief self-test. Then shortly
the software version installed on the handheld is shown.
After the self-test, the handheld should show the result:
• the audio icon on the handheld is activated,
• the bluetooth connection is not activated. The Bluetooth icon is blinking, as
the handheld is not connected to the basestation.
2. Attach a new disposable mouthpiece.
3. The handheld device might be busy. Wait until the clock icon stops blinking.
Press the ENTER button to start the regeneration cycle.
While the handheld is regenerating, segments of the display will be animated to
indicate the handheld is preparing the measurement.
Instructions for use © Bosch Healthcare Solutions GmbH
Measure
31