4.
Faults
4.1
No communication with BEA 050
and/or RTM 430
i
Information on checking and repair of the BEA 050
and/or the RTM 430 can be found in the following
documentation:
R
"BEA 050" 1 689 975 164
R
"RTM 430" 1 689 975 135
R
"Interface settings" 1 689 978 427
4.2
No communication with the measure-
ment unit
Possible causes:
R
Power supply (for checking refer to Section 5.1).
R
USB connecting cable (for checking refer to Section
5.11).
R
Measurement unit (replace the measurement unit if
none of the other possible causes is applicable).
R
Computer unit (check by connecting a customer
service PC).
4.3
No speed signal
Possible causes:
R
B+ /B- (for checking refer to Section 5.3).
R
Term. 1/15 (for checking refer to Section 5.4).
R
Clip-on trigger (for checking refer to Section 5.5).
R
Measurement unit (replace the measurement unit if
none of the other possible causes is applicable).
4.4
No temperature display
Possible causes:
R
Temperature sensor (for checking refer to Sec-
tion 5.2).
R
Measurement unit (replace the measurement unit if
none of the other possible causes is applicable).
4.5
No battery voltage
Possible causes:
R
B+ /B- (for checking refer to Section 5.3).
R
In the event of malfunction, replace either the mea-
surement cables or the measurement unit.
Robert Bosch GmbH
Faults | BEA 810/840/850 | 13
BEA 810/840/850 | 13
4.6
No pressure display
Possible causes:
R
Pressure sensor (for checking refer to Section 5.10).
R
In the event of malfunction, replace the measure-
ment unit.
4.7
No current display
Possible causes:
R
Input/multi measurement cable CH1 (for checking
refer to Section 5.6).
R
Input/multi measurement cable CH2 (for checking
refer to Section 5.7).
R
Current probe 30 A.
R
Current probe 1000 A.
4.8
Timing light not functioning
Possible causes:
R
Timing light (for checking refer to Section 5.9).
R
Measurement unit (replace the measurement unit if
none of the other possible causes is applicable).
4.9
Remote control not possible
Possible causes:
R
Remote control unit (check using reference remote
control unit).
R
Remote control unit batteries (check using multime-
ter).
R
Remote control receiver (check the firm attachment
of all cables, connect up the keypad directly and
check, replace the remote control receiver with a
reference unit if applicable).
4.10
Operation with mouse not possible
Possible causes:
R
Mouse (check firm attachment of connector, check
with reference mouse).
R
Computer unit (check using customer service PC).
4.11
No keypad operation
Possible causes:
R
Remote control receiver (check the firm attachment
of all cables, connect up the keypad directly and
check, replace the remote control receiver with a
reference unit if applicable).
R
Keypad (check using customer service PC).
R
Computer unit (check using customer service PC).
| 13
de
|
1 689 975 199
2009-09-25