Fluke Calibration 5560A Programmer's Manual page 63

COILTYPE_D?
x x
IEEE-488 USBTMC
Returns the default external current coil type used at power on and reset.
Parameters: None
Example: COILTYPE_D? returns C5500A50T
The default external current coil type is set to the 5500 50 turn coil.
COMM_ENABLE
x x
IEEE-488 USBTMC
Enables or disables a remote interface port.
Parameters: 1. SERIAL, TELNET, GPIB, TMC
2. 1. (Boolean) ON or 1 for on, OFF or 0 for off.
Example:
COMM_ENABLE SERIAL, OFF
Disables the RS-232 Interface.
COMM_ENABLE TELNET, ON
Enables the telnet interface port.
COMM_ENABLE?
x x
IEEE-488 USBTMC
Returns the active status of the interface port.
Parameters: 1. SERIAL, TELNET, GPIB, TMC
Response: ON if the interface is active, OFF if the interface is disabled.
Example:
COMM_ENABLE? SERIAL
Returns ON if the RS-232 interface is enabled/active, OFF if the RS-232 interface is disabled.
COMM_LOCK
x
x
IEEE-488 USBTMC
Locks out certain remote commands from executing on a specified remote port.
Parameters: 1. SERIAL, TELNET, GPIB, TMC
2. 1. (Boolean) ON or 1 for on, OFF or 0 for off
Example: COMM_LOCK SERIAL, OFF Disables the lockout feature on the RS-232 Interface.
COMM_LOCK TELNET, ON
interface port.
x
x x
RS-232 Ethernet Sequential
x
x x
RS-232 Ethernet Sequential
x
x x
RS-232 Ethernet Sequential
x
x x
RS-232 Ethernet Sequential
Enables the command lockout feature on the Telnet
Overlapped Coupled Lockout
x
Overlapped Coupled Lockout
Overlapped Coupled Lockout
x
Overlapped Coupled Lockout
Calibrator
Remote Commands
59