Grizzly G0561 Owner's Manual page 22

17. Place chip screen into opening shown in
Figure 22.
Chip Screen
Figure 22. Chip screen installed.
18. Unbolt machine from pallet.
19. Insert round steel bar stock through (4) lifting
holes in machine base (see Figure 23).
Note: Bar stock must be at least
eter and 3 feet long. Otherwise, it may not
be big enough to properly support weight of
machine.
20. Attach lifting slings to steel bar stock and
power lifting equipment (see Figure 23).
Power Lifting
Equipment
Front
Lifting
Strap
Round
Steel Bar In
Lifting Holes
Figure 23. Lifting machine with forklift and lifting
slings.
-20-
19. With assistant helping to stabilize load, lift
machine just high enough to clear pallet.
20. Remove pallet, then place wooden blocks
under machine so it will be supported 4" off
the ground, then lower machine.
21. Remove lifting slings and steel bar stock.
22. Slide axle through rear holes in bottom of
cabinet.
23. Slide (1) flat washer onto each end of axle,
followed by (1) wheel and another washer.
Secure wheels with cotter pins, as shown in
Figure 24.
⁄ " diam-
1
2
Axle
Figure 24. Wheels secured with cotter pin.
24. Install (1)
onto each leveling foot, then thread feet into
front base of cabinet, as shown in Figure 25.
Rear
Lifting
Strap
Cotter Pin
(1 of 2)
⁄ "-16 hex nut and
3
8
x 2
Figure 25. Leveling feet attached.
Model G0561 (Mfd. Since 01/18)
Washer
(1 of 2)
⁄ " flat washer
3
8
Leveling
Foot
(1 of 2)