Grizzly G0561 Owner's Manual page 21

9. Use straightedge to check pulley alignment.
If pulleys are not aligned, loosen motor pul-
ley set screws (see Figure 15 on Page 18),
adjust pulley, then re-tighten set screw.
10. Slide collar onto bottom side of pulley cover
and snap in place, as shown in Figure 18.
Figure 18. Collar installed.
11. Remove (2) pre-installed
" flat washers (see Figure 19).
bolts and ⁄
1
4
12. Slide pulley cover over pulleys (see
Figure 19).
13. Align holes and secure with fasteners you
removed in Step 11 (see Figure 19).
Figure 19. Pulley cover installed.
Model G0561 (Mfd. Since 01/18)
Collar
⁄ "-20 x ⁄ " hex
1 1
4 2
x 2
Entanglement Hazard! You
MUST install the pulley
cover before operating or
severe injury may occur.
14. Close pulley cover lid and secure with
x ⁄ " knob (see Figure 20).
5
8
Figure 20. Secured pulley cover lid.
15. Move coolant tank into cabinet.
16. Push hose over coolant tank fitting and
secure with hose clamp (see Figure 21).
Coolant
Hose
Fitting
Figure 21. Coolant hose installed.
⁄ "-20
1
4
Knob
Hose
Clamp
-19-