Aligning The Drill Bit - Drill Master XP User Manual

Aligning the Drill Bit

This makes sure that the Drill Doctor creates the right
geometry. And, it sets the bit so that only a small amount
of the tip is taken off.
(See page 21 to align and sharpen a Masonry drill bit.)
1.
1"
2.
Alignment Button
Alignment
Port
118˚
12
Insert bit in Chuck
and tighten
Insert the bit into the Chuck
Jaws and close the Jaws just to
the point where the bit slides in
and out. Do not over tighten the
Chuck; the bit needs to be able
to move in and out until Step 4.
Note: A good test to see if the
Chuck is tightened the correct
amount is to make sure it
moves when you pull on it with
your fingers, but will not fall
out when you turn the Chuck
upside down.
Insert Chuck into
Alignment Port
Drill Stop
Notch on the Alignment
Port.
While holding the button
down, slide the drill bit for-
ward until it touches the Drill
Stop and the Chuck is pullsed
all the way into the Align-
ment Port.
Alignment Button.
Alignment
Guide
www.drilldoctor.com
Press the Align-
ment
down and hold
it. Match the
either of the
A l i g n m e n t
Guides on the
Chuck with the 118°
Insert the Chuck.
Release the
Button