Masonry Drill Bits - Drill Master XP User Manual

Masonry Drill Bits

To sharpen a masonry bit, you do not turn the chuck.
Instead you insert the chuck until it touches the wheel,
remove, and repeat on the other side.
1.
Masonry
Sharpening
Marks
2.
www.drilldoctor.com
Align the bit with the
Masonry Sharpening
Marks
Insert the bit into the Chuck
and line up the carbide insert
on the tip of the bit so that it is
parallel to the Masonry Sharp-
ening Marks on the end of the
chuck. Leave about 1/2"–5/8"
of bit sticking out past the
nose of the Chuck. Tighten the
Chuck just to the point where
the bit slides in and out.
Set the depth
Sharpening Guide
Cam Guide
Sharpening Port
until it stops and tighten the
Chuck. Remove the Chuck to
ensure the insert is aligned
with the Masonry Sharpening
Marks and tighten again.
Set the depth
by lining up the
S h a r p e n i n g
Guide with the
Cam
Making sure
the Cam stays
against
Guide, push the
Chuck into
Sharpening
Guide.
Cam
the
Port
21