Advertisement
o The laser can not be pointed at a person's eye for more than 0.25s.
o Always make sure that the laser beam is directed to a solid piece that does not have a
reflective surface such as a piece of wood or a rough, matte surface. A glossy steel sheet
or similar material is not suitable for use with the laser because a reflective surface can
return the laser to the operator.
o Do not replace the laser light device with a different laser product. Repairs must be
performed by the manufacturer of the laser product or its authorized dealer.
Caution: Use of controls or adjustment or application of procedures other than those specified
in this manual may result in exposure to hazardous radiation.
Residual risks
Warning: When using a power tool, basic safety precautions should be taken to avoid the risk
of fire, electric shock or injury to persons.
Please read the additional safety instructions in this manual carefully and note that even if the
power tool is used in accordance with the operating instructions, it is not entirely certain that all
residual risk factors will be eliminated. The following hazards can occur:
o Contact with blade
o Rebound of the workpiece or debris of the workpiece
-
Fracture of the blade.
-
Ejection of debris from the machined part.
-
Hearing damage if you do not wear ear plugs.
-
Projection of wood chips that are harmful to health when the tool is used in a poorly sealed
room.
It is therefore important to take preventive measures:
o Always use a sawdust disposal device if possible.
o Do not use deformed or cracked blades.
o Remove the plug from the power tool before any adjustment or maintenance, including
replacement of the blades.
o Choose a suitable blade for the material to be cut.
o Do not use the saw to cut material other than those designated by the manufacturer
The miter saw can be transported safely by the main handle, but only when it has been
disconnected from the power outlet and locked in the locked position.
Do not use the saw when the guards are not properly assembled, in good condition or properly
maintained.
Make sure that the arm is securely secured during bevel cutting.
Apply the workpiece strongly against the swivel table on which there should be no other pieces
of wood.
Install sufficient lighting.
Make sure you have been trained or trained and know how to adjust and use this tool.
Use blades that are properly sharpened and do not exceed the maximum rated speed.
Do not pick up debris from the cutting area until the blade guard closes and the saw comes to
a complete stop.
Attach the miter saw to a workbench if possible.
When cutting a long piece that extends far beyond the width of the table, supports must be
used to support the ends of the workpiece at the same height as the cutting table.
5
Advertisement
