Advertisement
The start-up after the adjustments and checks is carried out by pressing the trigger switch located on the
main handle.
Connect the machine to the 230V mains.
You can stop the device by releasing the power switch located on the handle.
You should never stop the blade rotation by exerting lateral pressure on it.
Before you start cutting, the saw should reach its maximum speed.
Lower the saw head slowly and exert pressure depending on the composition of the materials to be cut.
When cutting, the wood should be well pressed against the stop rail.
For longer wood, you need to use side extensions.
After cutting, release the switch and re - attach the head in upper and locked position, making sure of
locking it.
After the cutting, the translucent blade guard closes automatically and covers the saw blade.
Run idle for 30 seconds in a safe position, stop the machine immediately if there is a relevant vibration or
other faults are detected.
If that is the case, check the machine to determine the cause of the fault.
You can stop the machine by releasing the trigger.
b) Use
Before any use, check that the blade is properly mounted and the stop is properly adjusted according to the
desired use.
Make sure that the lower mobile guard works properly and that the blade enters freely into the groove of the
working table by lowering the idle head while the motor is turned off.
If necessary re - adjust the cutting angle.
The translucent mobile guard should be replaced if it is cracked or damaged.
Tighten the workpiece in the vise on the working table.
CAUTION!
• Always observe the maximum widths and heights of the workpiece provided in the paragraph "Technical
features".
• If the workpiece's length is greater than 1 m, special precautions should be taken, such as support by
using shims at regular intervals under each end beyond the working table.
• Connect the power cable to a wall socket, checking that the voltage corresponds to that shown on the
nameplate of the machine.
• After turning the power on, wait a few seconds for the blade to reach its speed.
• Lower the cutting head slowly towards the workpiece and start working.
• Do not force the head: the advancement speed should be compatible with the material to be cut.
• At the end of the work, release the trigger switch and slowly raise the cutting head in upper position.
• The opening of the vise and cleaning of the waste should be done only when the machine is turned off,
the cutting head back in upper position, the movable guard closed and the blade completely stopped.
Instructions for cutting:
1. Unlock the head of the saw: exert pressure downward on the handle, pull the locking pin located at the
rear of the machine so that the head can return to its proper operating position.
2. Unlock the table
3. Rotate the table until the indicator reaches the desired angle on the scale tab
4. Secure the tab lock lever.
5. Before turning the saw on, run a test on the idle machine to make sure that the cutting is not difficult.
6. Firmly grasp the handle of the saw and squeeze the trigger. Wait a few seconds so that the blade can
reach its maximum speed.
7. Press your thumb against the lower blade guard locking device located on the handle.
8. Slowly lower the blade through the workpiece.
Advertisement
