Advertisement
f) Installation and change of the blade:
An accessory should be changed when the machine is idle and disconnected.
Pay attention to the direction of blade rotation, a superimposed arrow on the head of the saw shows
the direction of the blade rotation. The teeth of the saw blade should be oriented in the arrow
direction. Choose also a blade with a marking showing the rotation direction to observe.
Use only sharp blades and not damaged. Cracked or twisted blades should be replaced immediately.
Do not use HSS steel blades. Use only blades that are appropriate for the speed provided. Make
sure that the axis diameter and the axis hole are consistent.
g) Use of the laser:
This machine is equipped with a LASER generator.
• Laser switch: To turn the laser on push the "ON" button upwards and to turn it off the "OFF"
button downwards. You can use this button if you do not want to use the laser function.
To install or change the blades, your mitre saw should be in raised
position,
- Remove the front screw from the housing of the blade bolt (4).
- Lift the motor block blade and then the lower blade guard as high
as possible (note: take care, the lower blade guard is equipped with
a spring.)
Using the wrench, hold the flange (2) and then
loosen the bolt of the shaft (3) using the Allen key.
- Remove the flange of the blade and install or replace the blade
on the shaft. Make sure that the blade is
properly installed, the teeth directed downwards at the front of the
saw.
- Place again the flange of the blade firmly against the blade.
- Tighten the bolt of the shaft by turning it to the left. Using the
wrench, hold the flange and tighten the bolt of the shaft using the
Allen key.
- Push with your thumb on the locking device of the lower blade
guard so that the blade guard covers the blade.
- Tighten the housing screw of the blade bolt.
- Check the locking device of the lower blade guard is properly in
place and that it properly blocks the latter.
Advertisement
