Advertisement
j) Use of the stop:
Your mitre saw is equipped with a fixed part stop as well as removable stop, on the right and left side: they
allow immobilizing the workpiece during the cutting operation and thus prevent it from moving.
You should always push the workpiece against the latter, regardless of the type of cut to be performed.
The mitre gauge should be systematically adjusted to perform a cut.
k) Adjustment of the drive belt tension
Checking, adjustment of the drive belt tension and replacement:
- Remove the black plastic cover by unscrewing each
screw
- Check the belt tension by exerting pressure with the
thumb.
- When the belt should be tightened or replaced.
Unscrew the four fixing screws of the motor by about a
turn.
Tighten or replace the drive belt.
For rear tension move the motor backwards.
Tighten the fixing screws of the motor crosswise.
- Put back in place the black plastic cover and then
tighten it.
8 - Start-up
The base of your saw should be placed and well fixed on a solid, flat surface in a place inaccessible to
children.
Ensure the proper tightening of the safety components and blade before starting,
a) Start-up
CAUTION: This mitre saw is also equipped with an adjustable
stop. These stops should be adjusted to match the cutting
angle (straight cut, bias cut, etc...).
Advertisement
