Table of Contents
Advertisement
Driftwood Media Kit Installation (Part #761-931)
G800
1. Place the media tray over the burner, as shown below.
2. Attach the media tray with two screws, one on the middle-left and
one on the middle-right of the tray, as shown below.
3. Place Log #1 at the back of the firebox, centered as shown below.
The bottom points of the log should touch the media tray, and the
back of the log should touch the back firebox panel.
920-400
DRIFTWOOD MEDIA TRAY INSTALLATION (PART #761-931)
Page 1
4. Add the three supplied stones to the tray in the locations shown.
The stones must not cover the burner porting.
5. Add the supplied grey and black ember media (1.5 lbs total) and
spread it across the tray and around the stones in an even layer.
IMPORTANT:
1. Ensure that at least 50% of the gas burner porting
remains uncovered. Do not cover the pilot area or place
any embers on the pilot cover.
2. Ensure there is no ember media underneath the three
stones - they must sit directly on the media tray.
installation
Grandview
G800EC Gas Fireplace |
®
09.29.22
75
Advertisement
Table of Contents
